Review Boon

Home and tech products, reviewed

Kitchen Guide

Range tip-overs: the anti-tip bracket, the stability tests and what CPSC staff found

Our take

Voluntary standards have required new ranges to come with an anti-tip bracket since 1991, CPSC says. What its staff found when they evaluated range stability.

By Review Boon Team · · 6 min read

Key points

  • Voluntary standards have required new ranges to come with an anti-tip bracket since 1991, CPSC says; in all nine tip-overs its staff investigated in depth from 2000 to 2008, it was not installed or not properly engaged.
  • As CPSC staff described them in 2011, the standards tested an unsecured range with 75 pounds on the open oven door and required it to withstand 250 pounds, which most makers met with the bracket.
  • CPSC's 2023 tip-over report lists 9 deaths involving a stove or oven from January 2013 to July 2023; by our reading of its chart, 7 were children.
  • CPSC staff's 2011 report argued for a stricter 100-pound test; a UL task group had found the tests still appropriate in 2009, and warnings and labels were added instead, effective February 2012, CPSC says.
  • CPSC describes how to check a bracket, including a tilt test, and suggests an authorized technician for anyone not comfortable doing it.

A freestanding range looks too heavy to fall, but it can tip forward when enough weight presses on its open oven door. According to the U.S. Consumer Product Safety Commission (CPSC), voluntary safety standards have required new ranges to come with an anti-tip bracket since 1991. The bracket is usually a fork-shaped piece of metal fixed where the floor meets the wall behind the range, with one of the range's back feet sliding into it, or a bracket attached to the wall. It does nothing if it stays in the box: in all nine of the CPSC's in-depth investigations of range tip-overs from 2000 to September 2008, which involved 13 deaths, the anti-tip hardware was not installed or not properly engaged. This guide explains the stability tests behind the bracket as CPSC staff described them in 2011, what the staff found when they studied tip-overs, and how the agency says to check a bracket.

The stability tests, as CPSC staff described them

CPSC staff's May 2011 report names UL 858, the standard for household electric ranges, and ANSI Z21.1, for gas ranges, and describes the two as having identical stability requirements, with one test for normal use and one for abnormal use.

Stability tests for freestanding ranges in UL 858 and ANSI Z21.1, as described in CPSC staff's May 2011 report
TestLoad on the open oven doorTo pass
Normal use75 lb on the middle of the door of an unsecured range (50 lb if the door is more than 36 inches above the floor), for 5 minutesThe range must not tip or move from the horizontal
Abnormal use (adopted by UL on June 3, 1991)250 lb on the geometric center of the doorA 4.6 lb weight in a 9-inch pan on top must not slide off

Most manufacturers meet the 250-pound requirement with the anti-tip bracket, the report says, by securing the range to the floor or to the adjacent wall or cabinets when it is installed. In other words, in our reading, the 250-pound test is usually met with the bracket installed, while the 75-pound test is the one an unsecured range has to pass on its own. These are the tests as CPSC staff described them in 2011; we have not read the current editions of UL 858 or ANSI Z21.1.

How tip-overs happen

CPSC staff reviewed 33 range tip-over incidents from 1980 to 2006 and found two things in common: the range was not secured to the wall, floor or cabinets, and enough weight went onto the open oven door to tip it forward. The victims fell into two groups. Young children, from about 15 months to 5 years old, were typically found trapped under the range after being near it without an adult watching, and where there were several children the younger sibling was usually the one trapped. Older adults were hurt when they used the open door for support.

The injuries go beyond the weight of the appliance. Hot liquids spilling from pots on the cooktop caused burns, and the staff report describes at least five incidents in which an older adult who lost their balance and fell onto the open door was trapped under the range with the oven still on, suffering burns each time the oven cycled on.

What CPSC's 2023 tip-over report shows

CPSC's 2023 tip-over report, published in February 2024, counts 217 tip-over deaths reported from January 1, 2013 to July 31, 2023 involving TVs, furniture and appliances. Fifteen involved only an appliance: 9 a stove or oven and 6 a refrigerator. By our reading of the report's chart of appliance deaths, 7 of the 9 stove or oven deaths were children and 2 were seniors aged 60 or older. For injuries, the report estimates an annual average of 600 emergency department-treated injuries from 2020 to 2022 in tip-overs involving only an appliance, a category that also includes refrigerators, washers, dryers and microwaves, so the figure is not a count for ranges alone.

The report flags its limits. Deaths reach CPSC with a lag, so its counts for 2021 to 2023 are incomplete; CPSC changed the rules for which cases are counted, so the numbers cannot be set against its earlier tip-over reports; and it is a staff report that the Commission has not reviewed or approved. TVs and furniture were involved in most of the 217 deaths, as our guide to anchoring a TV explains.

What CPSC staff wanted changed

In 2009 and 2010, CPSC staff measured the forces that 13 children aged 15 months to 5 years exerted while climbing and standing on a mock open oven door, and tested four ranges to see what loads tipped them. Against a range that just meets the 75-pound test, 15 of the 72 recorded events involving up to two children on the door, or 20.8%, would have tipped it over, by the staff's analysis; the report's executive summary gives 26%. A range built to withstand 100 pounds unsecured would have cut that to 1 in 72, about 1.4%, although two children around age 5, or more than two children, could still tip it.

The staff concluded that a 100-pound test for unsecured ranges could reduce tip-overs, and floated two further ideas: an oven door that locks in the open position once the range starts to tip, and an automatic shutoff of the heat when it has tipped. A UL task group that included a CPSC staff member had reviewed the requirements in 2009 and concluded that the existing stability tests were still appropriate. Its proposals, which UL's standards panel adopted, dealt instead with awareness and installation: an anti-tip warning on the front of the range visible when the oven door is open, a peel-off label explaining how to check the stability device, warnings on the first page of the user's guide and installation instructions, a bracket designed to allow more than one way of securing the range, and bracket hardware packed with the installation sheet. CPSC gives February 18, 2012 as the effective date of those changes to UL 858.

The CPSC's voluntary standards page on freestanding ranges, dated May 3, 2011, says staff is continuing to review the need for additional performance requirements. It also lists proposals CPSC staff sent to UL's 858 standards panel on October 24, 2011; this guide does not cover what became of them. A Federal Register search on November 18, 2026 found no CPSC rulemaking on range tip-overs since January 2023.

How the CPSC says to check a bracket

The CPSC's tip sheet on checking a range's stability starts with the installation directions in the owner's manual. With the range cool and cleared of pots and other items, it suggests pulling out the bottom drawer and shining a flashlight underneath to see whether one of the back feet sits in a floor bracket, or looking behind the range for a wall bracket. Alternatively, it says, the range can be slid about three inches from the wall to look from both sides, then pushed back so that a rear leg or the back of the range engages the bracket.

To confirm the bracket is doing its job, the CPSC describes grasping the back of the range and trying to tilt it forward: if it tilts more than an inch, the range is not engaged or the bracket is not attached properly. Anyone not comfortable doing this, it says, should have an authorized appliance service technician check. For a range made after 1991 with a missing or faulty bracket, the agency points owners to their appliance retailer, property manager or homebuilder, or to the manufacturer for a replacement; for an older range, it suggests asking the manufacturer about a retrofit device. Our guide to induction cooktops and ranges covers choosing a range.

This guide is based on CPSC's page on freestanding kitchen ranges (dated May 3, 2011), CPSC staff's report "Range Tipovers: An Evaluation of Range Stability" (May 2011), the CPSC tip sheet on checking a range's stability (Publication 5007) and CPSC's 2023 tip-over report (February 2024), all read on November 18, 2026, and a Federal Register search the same day. We have not read the UL 858 or ANSI Z21.1 standards themselves, and we have not tested or assessed any range.

Sources

  1. Free Standing Kitchen Ranges (voluntary standards topic page) U.S. Consumer Product Safety Commission, May 3, 2011
  2. Range Tipovers: An Evaluation of Range Stability (CPSC staff report) U.S. Consumer Product Safety Commission, May 2011
  3. Tips on Checking your Range's Stability (Publication 5007) U.S. Consumer Product Safety Commission, 2011
  4. Product Instability or Tip-Over Injuries and Fatalities Associated with Televisions, Furniture, and Appliances: 2023 Report U.S. Consumer Product Safety Commission, February 2024

Researched and drafted with AI assistance, then checked against the 4 sources above in a separate fact-check on November 18, 2026. Spotted an error? Tell us.