Review Boon

Home and tech products, reviewed

Buying Guides

Revised button battery standard becomes mandatory February 13, 2027, CPSC says

Our take

UL 4200A-2026 makes the warning symbol on button and coin battery products more prominent, while the tests stay the same, the CPSC said on November 18.

By Review Boon Team · · 4 min read

Key points

  • A CPSC direct final rule published on November 18 says UL 4200A-2026 becomes the mandatory standard for products containing button or coin batteries on February 13, 2027.
  • The changes concern warnings: the Safety Alert Symbol must be at least as tall as the word “WARNING,” and the alternative product marking may be molded or stamped in one color.
  • Testing requirements are unchanged, and labs accepted for the 2023 version are considered capable of testing to the new one, the CPSC says.
  • The rule takes effect unless the CPSC receives a significant adverse comment by December 18, 2026, and applies to products manufactured after February 13, 2027.

The federal safety standard for products that run on button or coin cells, a group the Consumer Product Safety Commission (CPSC) has illustrated with TV remote controls and garage door openers, is getting its first revision since it became mandatory in 2023. In a direct final rule published in the Federal Register on November 18, 2026, the CPSC said the revised voluntary standard, ANSI/UL 4200A-2026, will become the mandatory standard for consumer products containing these batteries on February 13, 2027. The Commission voted 3-0 to publish it. The rule settles the review that our guide to Reese's Law described as still open on November 16.

Until that date, UL 4200A-2023 remains the mandatory standard, and the CPSC says the new version will apply to products manufactured after February 13, 2027.

What changes on the warnings

The CPSC describes the revision as clarifications to the packaging and product marking requirements. In the revised standard's warning figures for packaging and products (Figures 7B.1 to 7B.4 and 7C.1), the Safety Alert Symbol must be at least as tall as the signal word “WARNING.” In the 2023 figures it was slightly smaller. The CPSC says the change matches section 6.3 of ANSI Z535.4, the American national standard for product safety signs and labels, and makes sure the symbol is displayed prominently.

The second change concerns the alternative product marking in section 7C.2, which combines the Safety Alert Symbol with a button/coin cell symbol. On a printed label in more than one color, the marking must use the color shown in the standard. The revision clarifies that when the marking is molded or stamped into a product, the icon may be the same color as the part. The 2023 version did not directly address molded or stamped parts, according to the CPSC, which calls such markings a durable way to show safety information. Under a section carried over unchanged, every warning statement or icon must still be prominent, legible, easy to make out under normal lighting and permanently marked.

What stays the same

UL 4200A-2026 does not change the testing requirements, test equipment or test protocols, the rule says, so the way laboratories check compliance stays the same. The CPSC considers labs it has accepted for testing to the 2023 version capable of testing to the new one, and their existing accreditation criteria remain in place. By our reading, the CPSC's description of the revision lists no change to the battery compartment requirements.

The rule also restates how certification works. Children's products containing button or coin batteries must be tested by a CPSC-accepted third-party laboratory, while makers and importers of other products issue a general certificate of conformity based on a test of each product or a reasonable testing program. Once in effect, the federal standard preempts any state requirement on the same risk of injury that is not identical to it.

How the revision reached this point

Steps in the revision of the button and coin battery standard, as given in the CPSC's Federal Register notices of September 3 and November 18, 2026
DateStep
July 22, 2026UL Standards and Engagement (ULSE) publishes UL 4200A-2026
August 17, 2026ULSE notifies the CPSC of the revision
September 3, 2026CPSC notice asks for comments by September 17
November 18, 2026CPSC publishes the direct final rule
December 18, 2026Deadline for significant adverse comments
February 13, 2027UL 4200A-2026 becomes the mandatory standard

Reese's Law sets the timetable. A revised standard becomes mandatory 180 days after the CPSC is notified, unless the Commission decides that the revision, in whole or in part, does not improve safety, or sets a later date. The Commission did neither: it concluded that UL 4200A-2026 increases the safety of products with these batteries. Its September notice had given the notification date only as “August XX, 2026,” and one commenter noted that it lacked an accurate date. The new rule puts the notification on August 17, 2026.

The CPSC received 37 comments on that notice. One commenter supported changes that help consumers see and understand the warnings; another made acceptance conditional on the revisions adding clarity, widening coverage or making child-resistant enclosures perform better. Thirty-three comments raised the child-protective packaging required for packs of the batteries themselves, especially hearing-aid batteries. The CPSC said those fall outside this update and did not address them.

What could still change

Because the revision becomes mandatory by operation of law, the CPSC says public comments would not lead to substantive changes, and it chose the direct final rule route because it does not expect significant adverse comments. If one arrives by December 18, 2026, it will withdraw the rule before it takes effect, and may then issue a new direct final rule or a proposed rule. Comments are filed under docket CPSC-2023-0004. A free read-only copy of the standard is on UL's website, according to the rule.

This article is based on the CPSC's direct final rule of November 18, 2026 (91 FR 74086), its notice of September 3, 2026 (91 FR 56604) and its 2023 direct final rule (88 FR 65274), all read on GovInfo on November 18, 2026. We have not read the UL standard itself, and we have not assessed any product.

Sources

  1. Safety Standard for Button Cell or Coin Batteries and Consumer Products Containing Such Batteries, direct final rule, 91 FR 74086 Consumer Product Safety Commission, Federal Register (GovInfo), November 18, 2026
  2. Notice of Availability and Request for Comment: Revision to the Voluntary Standard for Products Containing Button Cell or Coin Batteries, 91 FR 56604 Consumer Product Safety Commission, Federal Register (GovInfo), September 3, 2026
  3. Safety Standard for Button Cell or Coin Batteries and Consumer Products Containing Such Batteries, direct final rule, 88 FR 65274 Consumer Product Safety Commission, Federal Register (GovInfo), September 21, 2023

Researched and drafted with AI assistance, then checked against the 3 sources above in a separate fact-check on November 18, 2026. Spotted an error? Tell us.